I was referred to this shop by another that said they were stand up guys. My experience wasn't the best. I brought in a rebuilt 1976 dodge van. My issue was when I floored the gas, the van would hesitate and fall flat on its face. The fuel was being starved some how but I wasn't sure what it was. The fuel pump was a month old, I replaced the fuel filter the day before, I couldn't find any crimps in the line, the carb had just been tuned a week ago. I figured I needed to take it to a "professional". When I dropped it off, they were able to get the van in within a 15 hour notice which was nice. I dropped it off at 8am and by 2pm they took it for a test drive and couldn't get it to have any issues. I drove the van with one of the mechanics and the second I was able to floor it, I got it to do the problem. They told me it was the fuel pump which didn't make sense to me but they said I needed the heavy duty pump that came with the big block V8s. I wasn't to familiar with these older motors so I took their word for it. They threw in a new fuel pump and charged me $239.20 USD and called it fixed. I got the van around 4:20 and the second I floored it, the same problem. Since they closed at 5, they told me I would have to come back tomorrow. We were stuck spending another day in Sydney when we were suppose to be in New Brunswick that day. The next morning I took them for another test drive and then they had a look inside the fuel tank. My fuel tank filter aka fuel sock had deteriorated and collapsed into the line. They drilled the line to flow smoothly and welded on a larger fuel sock because no one uses the smaller sizes now a days. They put the van back together and then proceeded to charge me $228.94 USD. They did work with me on the prices but looking back at this, It cost me roughly $500 USD to replace a $5 part. Most mechanics start with the cheapest part to replace and work their way up to the most expensive but they did the opposite with me. I think a major issue was they didn’t know how to work on an older car or were at least out of practice. I left the shop with a half tank of gas. I made it 20 miles and filled the tank to be full. When I left the gas station, my tank read empty. This confused me but I could floor the van so I was in decent spirits. Over the next 4 days I came to realize that the float/bobber in my gas tank was filling up with gas and sinking at full tanks and when it was near 1/2 to 1/4 it would float a little. Since I didn’t have an address in Canada, this made it extremely hard to ship anything and no store had a float for me to buy. After investigating the brass float, you can see spatter that had melted small holes which allowed for it to take in gas and sink. When I called Sparkes to talk this issue over, they constantly said we wish we could help you out. At this point I was in Alberta and they told me to drive back to their garage and they would fix it for me. I asked for money back since I am repairing their mistake or for them to send me a new float but they kept saying, I wish we could help you out. They then ended up hanging up on me during our conversation. Not a pleasant experience and I would not recommend working with this shop till something changes.